Klarstein VINSIDER 24 BUILT-IN UNO Mode D'emploi page 26

EN
26
Mounting the wine cooler
1. Place the wine cooler in the cabinet and straighten it
2. Open the door, take 2 screws from the accessory pack and use the Phillips
screwdriver to insert the screws through the screw holes on both sides of the door
hinge or both sides of the cabinet as shown above (the screw holes are near the
door hinge).
3. Tighten the screws.
Attaching the door handle
• Remove the handle from the cabinet and remove
the 2 screws from the accessory bag.
• Open the door seal on the inside of the door
and insert the screws into the two handle holes
on the door. Place the handle on the screws from
the outside and tighten the screws with a Phillips
screwdriver.