Operational Modes - digigard DG85 Guide D'installation

(height) with the back cover's plastic tab (Figure
1 on page 26).
If another installation height is called for, readjust
the PCB accordingly. Any PCB adjustments
should be followed by a walk-test of the
protected area. Walk-testing verifies that the
required coverage is in place.
Ensure that the unit's front and back
cover are tightly joined together without
any spacing (around the rim of the unit)
before tightening the screw, otherwise
the weatherproof casing may be
compromised and moisture may enter
the unit.

Operational Modes

Digigard DG85 can function in two different
operational modes: DGP2 Mode or Relay Mode.
This option can only be configured using the DIP
switches.
Relay Mode: (DIP Switch 1 = OFF)
When set to Relay Mode, the Digigard DG85
functions as would any standard motion
detector by communicating its alarm and
tamper signals via relays. Apply power by
connecting the AUX+ and AUX- of the control
panel to the RED and BLK terminals of the
detector as shown in Figure 2 on page 27. The
GRN and YEL terminals are not used.
Installation Guide 3n