Screen Confi Guration; Setting The Day Of The Week And Time; Operation; Turning On/Off - Mitsubishi Electric CITY MULTI PKFY-P VBM-E Série Manuel D'utilisation

3. Screen Confi guration
Function Selection of remote controller
A
Standard Control Screens
OFF
B
Timer Monitor
MON
TIMER
OFF
° F° C
WEEKLY

4. Setting the Day of the Week and Time

TIME SUN
° C
° C
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK

OPERATION

Note:
The day and time will not appear if clock use has been disabled at
Function Selection of remote controller.
5. Operation

5.1. Turning ON/OFF

<To Start Operation>
Press the ON/OFF button .
• The ON lamp and the display area come on.
Note:
When the unit is restarted, initial settings are as follows.
Remote Controller settings
Mode Last operation mode
Temperature setting Last set temperature
Fan speed Last set fan speed
Airfl ow up/down
Mode
*1 Last setting might be applied depending on the type of the indoor unit.
*2 In case of the last setting is swing, airfl ow might be Downward 4 de-
pending on the type of the indoor unit.
6
Set Day/Time
TIME SUN
D C
° F° C
° C
ON
C
Timer Setup
SUN MON TUE WED THU FRI SAT
B
WEEKLY
Day of the Week &
Time display
ON/OFF
FILTER
CHECK TEST
CLEAR
COOL or DRY Horiz. outlet *1
HEAT Last setting *2
FAN Horiz. outlet *1
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
Function Selection of remote controller:
Set the functions and ranges available to the
remote controller (timer functions, operating
restrictions, etc.)
Set Day/Time: Set the current day of the week or time.
Standard Control Screens:
View and set the air conditioning system's op-
erating status.
Timer Monitor: View the currently set timer (weekly timer, sim-
ple timer or Auto Off timer).
Timer Setup: Set the operation of any of the timers (weekly
timer, simple timer or Auto Off timer).
<How to change the screen>
A
: Hold down both the Mode button and the Timer On/Off button for 2
seconds.
B
: Press the Timer Menu button.
C
: Press the Mode (Return) button.
D
: Press either of the Set Time buttons (
TIME SUN
Set Time button 1 to show display
1. Press the or
2. Press the Timer On/Off (Set Day) button
* Each press advances the day shown at
Sun Mon ... Fri Sat.
3. Press the appropriate Set Time button 1 as necessary to set the time.
* As you hold the button down, the time (at
one-minute intervals, then in ten-minute intervals, and then in one-
hour intervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
4
button to lock in the values.
2
5
6
1
2
<To Stop Operation>
1
Press the ON/OFF button again.
1
• The ON lamp and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting
down the operation is progress, the air conditioner will not start
for about three minutes. This is to prevent the internal components
from being damaged.
or ).
Day of the Week Setting
Time Setting
2
.
to set the day.
3
:
4
) will increment fi rst in
3
7
3
5
6
7