NORTH STATES 8657 Instructions page 5

PROPER SET-UP CONFIGURATIONS
We recommend that you use your
Petyard only as an enclosure, not as
a barrier. See FIGURE 7 at right for
proper configuration.
TO OPEN ENCLOSURE
To disconnect two adjoining panels,
select one of the three joints where a
dark gray carpet foot is facing up, as
shown in FIGURE 8 at right.
Gently press down on panel 1 while
lifting slightly on panel 2. This will
enable you to slide pin "C" free of
cylinder "D" (see FIGURE 6). Then
lift up on panel 1 until opening "A"
(see FIGURE 5) is free of pin "B".
PET DOOR OPERATION
Your enclosure comes from the
factory with the pet door in the
"LOCKED" POSITION (See FIGURE 9).
TO UNLOCK
Squeeze and twist the front center
knob located below the pet door. As
you twist, the knob will line up with
the arrows on the right or left sides of
the knob. The pet door will move
freely in both directions for your pet
to pass through.
TO LOCK
Squeeze and twist the front center
knob located below the pet door. As
you twist, the knob will be in the
upright position, keeping the door
securely locked.
!
WARNING
Make certain that the pet door is securely locked in the closed position if using with a
child 6-24 months of age.
FIGURE 7
INCORRECT
FIGURE 8
PANEL 1
FIGURE 9
Locked Position
Squeeze and Twist to Open
CORRECT
INCORRECT
Dark Gray
Car pet Foot
Open Position
(Front View)
Locked Position
(Back View)
Page 5
PANEL 2