NORTH STATES 8657 Instructions page 4

SET-UP INSTRUCTIONS
Begin setting up your enclosure by
unsnapping the gray carrying strap and
carefully unfolding the panels to form a
hexagon, as shown in FIGURE 3 at right.
(NOTE: Form an octagon when using eight
panels and a square when using four
panels).
When you have finished unfolding the
panels, there will be two unconnected
panels arranged as shown in FIGURE 4 at
right. Make certain that the dark gray
carpet foot (D) is up as shown.
Begin connecting the panels together by
gently lifting up on panel 1 and setting the
opening "A" (as shown in FIGURE 5) over
pin "B" located on panel 2.
Now locate the slot on the lower end of
cylinder "D", as shown in FIGURE 6.
This slot tapers to an opening that
accommodates pin "C".
Gently press down on panel 1 while
aligning pin "C" with the end of the slot in
cylinder "D". While maintaining downward
pressure on panel 1, lift slightly on panel 2,
and slide pin "C" through the slot and into
the opening as shown.
EXTENSION INSTALLATION
Two-panel extensions are sold separately.
An extension enables you to expand the
Petyard to a maximum of 34.4 square feet
(see page 2).
The extension is installed by following the
"SET-UP INSTRUCTIONS" that appear
above.
FIGURE 4
PANEL 1
P
FIGURE 5
PANEL 1 PANEL 2
OPENING A
PIN B
FIGURE 3
D
Dark
Gray
Car pet
PANEL 2
Foot
C
A B
FIGURE 6
PANEL 1
PIN C
Page 4
PANEL 2
SLOT IN
CYLINDER
D