Phottix Odin TTL Flash Trigger Manuel D'utilisation page 11

Using the AF Assist Illuminator
(AF-ILL) Function
Pressing the AF Assist Illuminator Function
button turns on/o
1. When turned on: AF Assist Illuminator Func-
tion will cause a ash' s AF assist lamp to
illuminate when the camera shutter button is
half-pressed.
2. When turned o : AF Assist Illuminator Func-
tion will be disabled and will not illuminate
when the shutter button is half-pressed.
Note:
AF-ILL Functions need to be enabled
in ashes custom function menus. See ash
instruction manuals for details.
Using the Clear Button
1. The Clear Button will erase any settings
currently in the TCU.
En
En
ashes AF Assist functions.
INSTRUCTION MANUAL
INSTRUCTION MANUAL
2. Press and hold the Clear button for 2 seconds
to remove TTL/M/O , Ratio, Zoom and EV
settings currently in the TCU.
3. The Clear button will not change or reset the
transmission channel (1, 2, 3 or 4) set on the
TCU.
Using the Test Button
The test button will re all ashes connected to
Phottix Odin receivers that are on the same
channel as the TCU.
1. Press the Test button.
2. Flashes will
followed by Group B and C.
FP High Speed Sync
High Speed Sync functions, with a maximum
shutter speed up to 1/8000 sec., are support by
re in sequence: Group A,
11