Phottix Odin TTL Flash Trigger Manuel D'utilisation page 10

Fast Exit
Pressing the TCU Power Button after making
changes to settings will exit edit mode. The
TCU will save the current settings.
Adjusting ash zoom
The Phottix Odin allows the zoom level of
ashes to be set wirelessly. Zoom can be set as
TTL or Manual.
TTL Zoom: Flash zoom setting will change
dynamically as a camera zoom ring is adjusted.
Manual Zoom: Flash zoom can be set to a xed
value on the TCU. Any changes made to
camera zoom will not a ect this setting.
Using the Zoom Function
1. Press the Zoom Button to enter the Zoom
screen – this functions the same in TTL/Mixed
or Ratio Modes.
10
2. Pressing the Selection button will cycle
through groups A, B and C, and Transmission
channel.
3. With groups A, B or C active: Press the Mode
Button to change from TTL to Manual mode. In
Manual Zoom, press the - / + buttons to adjust
the ash zoom. No adjustments can be made in
TTL mode.
Note:
Pressing the Selection button after the
CH selection will return to the TTL/Mixed or
Ratios Function Screen.
Fast Exit
Pressing the TCU Power Button after making
changes to settings will exit edit mode. The
TCU will save the current settings.