Cleaning; Injectors; Technical Specifications - smev CU322 Mode D'emploi

CLEANING

BEFORE CLEANING THE APPLIANCE ALWAYS TURN IT OFF AND DISCONNECT
FROM POWER SUPPLY AND WAIT UNTIL IT HAS COOLED DOWN.
SURFACES THAT ARE STILL HOT CAN BE DAMAGED IF THEY COME INTO
CONTACT WITH COLD WATER OR A DAMP CLOTH. NEVER USE ABRASIVE,
CORROSIVE OR CHLORINE BASED CLEANING PRODUCTS. NEVER USE STEEL
OR PLASTIC SCOURING PADS. NEVER LEAVE DEPOSITS OF ACID OR ALKALINE
SUBSTANCES (VINEGAR, SALT, LEMON JUICE ETC.) ON SURFACES OF THE
APPLIANCE. STAINLESS STEEL SURFACES AND ENAMELLED PARTS: CLEAN WITH
A WATER AND SOAP OR NEUTRAL DETERGENT SOLUTION, RINSE AND DRY. USE
CLEAN SPONGES OR CLOTHS TO CLEAN.
NEVER USE ABRASIVE AND / OR COARSE CLEANING MATERIALS OR METAL
BRUSHES TO CLEAN THE GLASS OVEN DOOR AS THESE MATERIALS SCRATCH THE
GLASS SURFACE WITH THE RISK OF SHATTERING THE GLASS.
NEVER USE STEAM CLEANERS TO CLEAN THE APPLIANCE.

INJECTORS

CLEANING OR REPLACING GAS INJECTORS MUST ONLY BE PERFORMED BY
AUTHORISED AND QUALIFIED GAS SERVICE ENGINEERS. THE MANUFACTURER
DECLINES ALL RESPONSIBILITY IN REGARD.
When removing and mounting the injectors the injector holder must be held in place with the aid of tool
(Fig. 6 - Pg.181).
BURNER
AUXILIARY (Ø 47 mm)
SEMI-RAPID (Ø 62 mm)
OVEN
GRILL

TECHNICAL SPECIFICATIONS

A label is affixed to all models containing all the technical specifications related to the appliance.
Fig. 7 - Pg.182 provides the technical specifications which are no longer visible after the appliance has been installed.
Ø INJECTOR (mm)
0,50
0,67
0,53
0,62
STAMPED N.
50
67
53
62