Haussmann 6139.468 Manuel De L'utilisateur page 27

ASSEMBLY
3. Attache cord wraps (N) to legs (C) with 2 screws (P), 2 washers (Q), and
2 nuts (R) as shown in Figure 4.
4. Move the front tabletop (H) towards the rear tabletop (G) by turning the
handles on the traverse assemblies (F) clockwise. See Figure 5.
5. Tighten the pan head screws (U) in position A. See Figure 5.
6. Open the table slightly by turning the handles counterclockwise. Tighten
the pan head screws (U) in position B, but do not overtighten. The
handles should turn freely. If motion is difficult, loosen screws 1/4 turn.
See Figure 6.
7. Tighten all nuts on base to complete assembly. Do not overtighten. The
table should be easy to fold. See Figure 7.
Fig. 4
B
B
Fig. 6
A
G
A A
A
H
F
OK
Fig. 5
Fig. 7
27