End Of Program; Interrupting A Program; Changing The Current Program; Canceling The Current Program - Foster KF60 Notice D'utilisation

2.2.3

End of program

The end of the program is signaled by a short beep. Additionally the indi-
cator light of the normal and strong programs (marked "end") flash.
2.2.4

Interrupting a program

To interrupt the current program simply open the door of the dishwasher;
to restart the program, simply close the door again. The program restarts
from where it was interrupted.
2.2.5

Changing the current program

To change the current program, simply open the door of the dishwasher
and select the new program. Close the door to run the new program au-
tomatically.
2.2.6

Canceling the current program

• To cancel the current program, open the door and press and hold down the
program selection button (ref. 3 fig. 2-02) for a few seconds until the indica-
tor lights of the fourth and fifth programs turn on (ref. pr. 4, pr. 5 fig. 2-03).
• Close the door again.
• After about 1 minute, the dishwasher terminates the cycle and the in-
dicator lights of the fourth and fifth programs (ref. pr. 4, pr. 5 fig. 2-03)
start flashing.
symbols programs according to the models
USER INSTRUCTIONS
simbolo fast cycles option (pag. 5 dell'ingles
e nella seconda parte della tabella programm
auto
auto
END
pag. 11 dell'in
FIG. 2-03
END
pag. 13 dell'in
EN
11