Black & Decker GS2400 Traduction Des Instructions D'origine page 9

Adjusting the cutter plate
The cutter plate needs to be adjusted if the appliance fails to
shred material.
Turn the adjustment knob (7) clockwise half a turn into the
u
cutting position to cut through light material completely.
Turn the adjustment knob counter-clockwise half a turn
u
into the crushing position to shred heavy materials.
The materials may need to be put through the appliance
twice to crush the material before cutting it completely.
Make sure the cutting blade does not touch the anvil blade
u
to avoid damage to the appliance.
When the shredded material starts to hang like a chain as
shown in fig. D, adjust as follows:
Switch the appliance on.
u
Turn very slowly and slightly the adjustment knob (7)
u
clockwise until you hear a light grinding sound or a small
amount of aluminium shavings will fall out of the discharge
chute. The shredded material will now be separated as
shown in fig. E.
Warning! Ensure the appliance is switched on and working in
normal forward direction. Adjusting the cutter plate while the
appliance is switched off can lead to serious damage of the
appliance.
Overload protection (fig. C)
This appliance has an overload protection. If the appliance
becomes blocked and the motor stalls, the power will
automatically be switched off.
Wait for about 5 minutes for the protection to reset.
u
Disconnect the appliance from the mains supply.
u
Clear the blockage as described above.
u
Connect the appliance to the mains supply.
u
Press the overload protection button (3).
u
Switch the appliance on.
u
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
u
Connect the brown lead to the live terminal in the new plug.
u
Connect the blue lead to the neutral terminal.
u
Connect the green/yellow lead to the earth terminal.
u
Warning! Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Protecting the environment
Z
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
z
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand for
raw materials.
Local regulations may provide for separate collection of
electrical products from the household, at municipal waste
sites or by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local Black & Decker office at the
address indicated in this manual. Alternatively, a list of
authorised Black & Decker repair agents and full details of our
after-sales service and contacts are available on the Internet
at: www.2helpU.com
Technical data
Voltage
Frequency
Power input
Motor duty class
at 2,400 W
at 2,000 W
No-load speed
Max cutting diameter
Weight
Notes
Motor duty class: S6-40% indicates a load profile of 4 min load and
6 min idle time.
Max cutting diameter: 40 mm.
ENGLISH
GS2400 Type 1
V 230-240
Hz 50
W 2,400
S6-40%
S1
min 46
-1
mm 40
kg 26.5
9