External Power Supply; Measuring Current - GMC-I PRO SyS ACP 3000 Mode D'emploi

______________________________________________________________
4.2 EXTERNAL POWER SUPPLY (ACP 3005)
An optional external power supply can be used with the
ACP 3005. The requirements are a stabilised 3VDC supply with
a minimum current output of 100mA.
terminated with a 2.1mm/5.5mm (0.08''/0.219'') power connector
(centre negative).
The unit is to be externally powered by a Listed Limited Power
Supply Only.
4.3

MEASURING CURRENT

Read safety section of instructions before operating this
product.
Ensure conductor to be tested is de energised
Connect the output of the electronics to the input of an
oscilloscope or other data recording device.
The flexible current probe is not for use on conductors
with a potential of over 1000V.
Wrap the flexible probe around the conductor to be tested,
close coupling. Energise the circuit under test. Locate the
coupling away from nearby conductors.
_______________________________________________________________
The supply is to be
(+terminal)
(- terminal)
8