Flashing Display Lights - GE Prolife PDW8700 Serie Manuel

6
Clean
PDW8700 Series and PDW8800 Series
The CLEAN light is illuminated when the selected cycle and enhancements are complete. The light will stay ON until
a pad is pressed or the door is opened and then closed.
PDW9200 Series and PDW9800 Series
The CLEAN light is illuminated and a double beep will sound when the selected cycle and enhancements are complete.
You may remove the dishes at any time. Note the high-efficiency fan will run quietly for 30 minutes to 4 hours (depending
on selected cycle) after the CLEAN light is illuminated to continue drying the dishes. The fan can be turned off by opening
the door and pressing any keypad.
NOTE: To turn off the audible end-of-cycle signal (or re-activate it if it was previously disengaged), press the HEATED
DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been toggled.

Flashing display lights.

Status Indicator Lights
START/RESET
Recommended dishwasher products.
GE recommends the following products for use in
its dishwashers:
s Cascade
®
automatic dishwasher detergents.
s Jet Dry
®
spots and prevent new film buildup on your
dishes, glasses, flatware, cookware and plastic.
s Cascade
®
inside your dishwasher that can come from some
tomato-based stains.
What It Means
Cycle has been interrupted by pressing the START/RESET pad. Light will
quit flashing after the dishwasher automatically drains out the water.
and Electrasol
® powder, liquid or gel
and Cascade Crystal Clear
® to remove
Plastic Booster ™
to remove red staining
s Cerama Bryte
®
Stainless Steel Appliance Cleaner
to clean the stainless steel panel of GE and
Profile ™ stainless exterior dishwashers.
s Jet Dry
® Dishwasher Cleaner to help remove
some hard water mineral stains that can occur
in hard water conditions.
ge.com
7