S&P COR-F-1000 N Notice D'installation Et D'utilisation page 16

OPERATION
REMOTE CONTROL CONNECTION
(This control is incorporated in the packaging of each air curtain)
CURTAIN MODEL
COR- F-1000 N
COR- F-1500 N
COR- F-2000 N
COR-3,5-1000 N
COR-6-1000 N
COR-9-1000 N
COR-9-1500 N
COR-12-1500 N
COR-18-2000 N
IF CONNECTION BETWEN TWO OR MORE AIR CURTAINS OF THE SAME MODEL (MAX. 5
UNITS), PLEASE REFER TO WIRING DIAGRAM FROM FIG. 6.
NOTE: In the case of multiple connection, Installer must consider the increased number of
feeders based on the number of connected units. In order to interconnect two or more cur-
tains it is predicted that the cables can go through their interior. FIG. 7 shows a lateral cover on
which a noticeable circular opening is present. This opening allows easy breakage, thus ena-
bling the installer to feed cables to the unit.
PROTECTION AGAINST OVERHEATING
The COR Air Curtains are fitted with one thermal fuse which automatically disconnects the unit
in case of overheating.
In the event of this happening please contact the official S&P dealer in your area.
MAINTENANCE
The COR Air Curtains do not need any special maintenance, but it is recommended to keep the
inlet and outlet grilles clean. Clean them with a dry cloth (avoid using solvents or abrasive
detergents). Once a year, the inside parts should be cleaned by a qualified electrician using
compressed air or a vacuum cleaner. Disconnect the unit from the mains supply before carry-
ing out this operation.
AFTER SALES SERVICE
In case of any problem with the unit, it is advised to contact your S&P dealer. Any manipulation
of the appliance by personnel not appointed by S&P will cancel the guarantee.
S&P reserves the right to modify the product without prior notice.
REMOTE CONTROL MODEL
CR-F
CR-3,5 N
CR-6/9 N
16