Safety; General Safety Instructions; Instructions, Standards And Regulations; Appliance Description - Stiebel Eltron SB-VTI 100 Utilisation Et Installation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
INSTALLATION

Safety

INSTALLATION
6.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1

General safety instructions

We can only guarantee trouble-free function and operational reli-
ability if original spare parts intended for the appliance are used.
6.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
7.

Appliance description

7.1

Required accessories

Depending on the static pressure, safety assemblies and pressure
reducing valves are available. These type-tested safety assemblies
protect the appliance against unacceptable excess pressure.
7.2

Additional accessories

Flanged immersion heaters are available as accessories.
If it is not possible to insert a rod anode from above, install a
segmented anode.
8.

Preparation

8.1

Installation site

f Always install the appliance in a room free from the risk of
f
frost and near the draw-off point.
f Ensure the floor is level. Use the adjustable feet to compen-
f
sate for any unevenness in the floor.
f Ensure the floor has a sufficient load bearing capacity (see
f
chapter "Specification / Data table").
f Observe the room height and height when tilted (see chapter
f
"Specification / Data table").
www.stiebel-eltron.com
Minimum clearances
The minimum side clearances can be swapped between left and
right.
≥800
f Maintain the minimum clearances.
f
8.2

Transport

For transportation, the appliance is secured to the pallet with
metal brackets.
f Remove the screws from the pallet.
f
f Turn the metal brackets to the inside of the adjustable feet
f
under the appliance.
Removing the appliance from the pallet
Material losses
!
Rolling the appliance off the pallet can damage the sheet
metal casing.
f Tilt the appliance using the adjustable feet to remove it from
f
the pallet.
f Set the appliance down on the floor on the adjustable feet.
f
≥300
SB-VTI |
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sb-vti 150Sb-vti 200Sb-vti 300Sb-vti 400Sb-vti 500

Table des Matières