INVENTOR M3GHP290-12 Manuel D'utilisateur page 16

I SENSE operation:
The I SENSE operation enables the remote control to
measure the temperature at its current location and
send this signal to the air conditioner every 3 minutes
interval.
NOTE: Press this button for seven seconds to start/
stop memory feature of I SENSE function.
If the memory feature is activated, "ON" will display for
3 seconds on the screen.
If the memory feature is stopped, "OF" will display for 3
seconds on the screen.
SHORT CUT
While the memory feature is activated, press the ON/
I SENSE
OFF button, shift the mode or power failure will not
cancel the I SENSE function.
SHORT CUT operation:
This button is used to restore the current settings or
resume previous settings.
Push this button when remote controller is on, and the
system will automatically revert back to the previous
settings including operating mode, setting temperature,
fan speed level and sleep feature (if activated).
If pushing more than 2 seconds, the system will auto-
matically restore the current operation settings includ-
ing operating mode, setting temperature, fan speed
level and sleep feature (if activated).
16