How To Connect The Cable; How To Change The Ear Pads - Beyerdynamic DT 700 PRO X Mode D'emploi

HOW TO CONNECT THE CABLE

u
The lockable connecting cable is fitted with a 3-pin
mini XLR cable connector to the headphones.
u
For correct assembly, the small release button of the
cable must face to the outer site of the headphone.
u
When connecting the cable, make sure
that the cable connector locks in place of the ear
cup.
u
Caution:
Connect the jack connector of the headphone
cable to a headphone socket only! If you connect
the headphones to any other jack socket, the head-
phones could be damaged.
release button
u
When you want to change the cable, please press
the small button for release and simultaneously pull
off the cable connector from the headphone.
release button

HOW TO CHANGE THE EAR PADS

u
To remove the ear pad, carefully pull apart the gap
between housing and ear pad using your fingertips
or a narrow blunt object.
u
To attach the ear pad, make sure that the snap-in
nose of the ear pad sits in the right place.
u
Then press gently with the palm of your hand
against the ear pad until the ring snaps into place.
4