Geberit SH Mode D'emploi page 12

10
Press the <Shower> button again. The spray arm
retracts. The dryer arm extends and the dryer
starts.
11
Remove your hand from the IR window of the user
detection. The dryer stops.
In the event of malfunctions, refer to chapter
"Malfunctions during operation" of the operating
instructions.
The remote control must be closer than 1 m to the
WC to enable it to detect the WC.
12
Slide the cover of the remote control up until it
reaches the stop position. Then remove the slider
by pressing the catch and insert the batteries
supplied (3 x size AAA / type 1.5 V) into the remote
control.
13
Remove the spray shield and store for later use.
14
Press the small button (which causes both buttons
to be pressed) to release a partial flush (3 l). Press
the large button to release a full flush (6 l).
12
Acceptance
Handing over the toilet to the customer, ready for
operation
1
2
3
4
2
1
≤ 1 m
3 l
Result
Functions successfully tested.
WC is ready for use.
Explain the main functions of the toilet to the
customer.
Refer to the operating instructions for detailed
information.
Hand over end-user documentation to the
customer.
Fill in the warranty card together with the customer
(end-user documentation), attach the serial number
sticker and send it to Geberit.
Attach a second serial number sticker, for example
to the last page of the operating instructions, so it is
available for later use.
6 l