Initial Commissioning - Geberit SH Mode D'emploi

Initial commissioning

An automatic commissioning programme is run before
inserting or filling the active carbon filter and nozzle
cleaner. This programme lasts 2–9 minutes.
Putting the WC into operation
Prerequisites
• Spray shield is positioned on the WC seat
1
Open the maintenance opening.
2
Press and hold the <Shower> button (1) while
switching on the power switch (2). Wait until the
dryer arm is extended and the blue LED flashes.
Commissioning programme starts.
1
2
The commissioning programme is active as long as
the blue LED is flashing. If an error occurs, the
programme is cancelled after 9 minutes and the
red LED flashes.
If the red LED flashes, the malfunction (e.g. lack of
water) must be rectified and the commissioning
programme must be restarted.
3
Check whether the commissioning programme is
completely finished (blue LED lights up).
4 Insert the active carbon filter.
5
Remove the screw cap of the nozzle cleaner. Pull
out the filling tray. Position the nozzle cleaner on
the filling tray and fill. Do not squeeze the bottle.
1
3
2
6
Reinsert the filling tray and close the maintenance
opening.
If active carbon filters and nozzle cleaners are not
inserted or refilled, the red LED will light up.
7
Cover the IR window of the user detection with
your hand and keep it covered.
8
Check whether the <Odour extraction unit> and
<Dryer> buttons are pressed on the control panel.
If not, press both buttons. Odour extraction unit
starts.
9 Press the <Shower> button. The spray arm
extends and the shower spray starts. Increase or
lower the shower spray intensity by moving the
slider forwards <+> or backwards <->.
EN
11