8.
Connect the Home 4G to a surge
protected AC power strip with at least a
1000 Joule rating. If your Home 4G is
working correctly, the lights will be green.
If the lights are orange or red, see the
"Troubleshooting" section on page 10.
NOTE:
Modern energy efficient dual-pane
windows with coatings will weaken
the cellular signals as they pass
through because of a metal oxide
film applied during manufacturing.
If you have dual-pane windows with
energy efficient coatings, we rec-
ommend one of the other mounting
options if your performance is not
to your satisfaction.
6
Need help?
Installation Options
Outside Pole Mount Option
(Best Option)
1.
2.
3.
www.weBoost.com
Select a location on the roof where the
Outside Antenna can be mounted on a
pole maintaining at least 20 feet of vertical
or horizontal separation from the inside
Desktop Antenna.
Place the desktop signal
antenna directly beneath the
placement of the Outside
Antenna location
At least 20 feet of vertical
or horizontal separation
from the desktop antenna
is needed
Find an existing pole or obtain a
pole of 1 to 2 inches in diameter.
Mounting hardware to attach the pole
to the roof can be purchased from a
hardware store or you can purchase a
weBoost's pole mount accessory kit,
part #901117. Install the pole in the
desired location.
Using the hardware in Packet A, slide
both brackets onto U-bolt. Tighten nut
& washers set onto U-bolt.
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST