Signal Booster Specifications - weBoost Home 4G Instructions D'installation

Masquer les pouces Voir aussi pour Home 4G:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Signal Booster Specifications

Model Number
Connectors
Antenna Impedance
Frequency
Passband Gain (nominal)
20 dB Bandwidth (MHz)
Typical
Maximum
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Power output for multiple
received channels (Uplink) dBm
No. Tones
Power output for multiple
received channels
(Downlinklink) dBm
No. Tones
Noise Figure
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory
reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase
coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected.
If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn
the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1
minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually
restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's
microprocessor.
The Manufacturer's rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are
present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to
adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the
device.
Need help?
SMA-Female on the Inside Antenna / F-Female on the Outside Antenna
704-746 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700 MHz
700 MHz
Band17
Band13
57.3
700 MHz
700 MHz
Band17
Band13
26.2
29.8
700 MHz Band17
700 MHz Band13
Band17
Band13
23.7
700 MHz Band17
700 MHz Band13
Band17
Band13
0.9
700 MHz Band17
700 MHz Band13
Band17
Band13
2
21.3
3
17.7
4
15.2
5
13.3
6
11.7
700 MHz
700 MHz
Band17
Band13
2
-2.0
3
-5.6
4
-8.1
5
-10.0
-11.2
6
-11.6
-12.8
www.weBoost.com
Home 4G
470001
75 Ohms / 50 Ohms
800 MHz
Band 5
55.0
57.2
800 MHz
Band 5
26.7
38.3
29.8
39.5
800 MHz
Band 5
23.6
24.6
800 MHz
Band 5
-1.0
2.1
Maximum Power
800 MHz
Band 5
20.7
23.0
17.2
19.4
14.7
16.9
12.8
15.0
11.2
13.4
Maximum Power
800 MHz
Band 5
-3.2
1.8
-6.7
-1.7
-9.2
-4.2
-6.1
-7.7
7 dB nominal
> 110 dB
AC / DC 5V, 2.5A, w/2.5x5.5mm Jack
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
1700/2100 MHz
1900 MHz
Band 4
Band 25/2
60.5
57.0
1700/2100 MHz
1900 MHz
Band 4
Band 25/2
73.5
78.4
73.8
80.1
1700 MHz
1900 MHz
Band 4
Band 25/2
24.9
23.3
2100 MHz
1900 MHz
Band 4
Band 25/2
5.8
6.1
1700 MHz
1900 MHz
Band 4
Band 25/2
19.9
18.1
16.4
14.6
13.9
12.1
11.9
10.2
10.4
8.6
2100 MHz
1900 MHz
Band 4
Band 25/2
-0.5
-2.2
-4.1
-5.8
-6.6
-8.3
-8.5
-10.2
-10.1
-11.8
15

Publicité

Chapitres

Table des Matières
loading

Table des Matières