How To Change Transmitter Batteries - Carson REFLEX WHEEL II Mode D'emploi

Charging Jack
GB GB
Charging
Jack
Note: ON/OFF Switch should be at "OFF"
position before charging the batteries for the
transmitter. Only Nickel-Metalhydride batteries
(NiMH), such as CARSON 50609000 or its
equivalents, are to be recharged. If you attempt to
recharge other types of batteries, they may burst
and cause injury or damage to you and others. DO
NOT RECHARGE OTHER TYPES OF
BATTERIES, SUCH AS ALKALINE!

How to change transmitter batteries

* To remove the battery cover, push the cover
locking and lift the cover. Insert AA batteries
respectively NiMH rechargeable batteries and pay
attention to the polarity. If the transmitter voltage
indicator LED fails to register, check the contacts,
8 REFLEX WHEEL II Radio Control System
Polarity of charging jack
Push and
lift here
Steering Rate Adjuster
Steering Rate Adjster
Strokes of the Steering Servo Horn can be
adjusted by rotating this Steering Rate Adjuster, in
the range from 10% to 100%. The bigger the
percentage is, the more sensitively the Steering
Servo operates.
especially the negative(-) terminals and recheck
that batteries are fitted correctly. Also make sure
the batteries are fully charged.
Item. No.: 50 050 0508