Bec-System/Connections To Receiver; Install The Transmitter Batteries - Carson Reflex Stick II 6 Channel 2.4 GHz Mode D'emploi

BEC-System/Connections to Receiver

BEC-receiver:
Battery eliminator is installed in the receiver circuitry. The receiver
gets supplied with current through the drive battery that runs the
engine. NiMH battery from 6 V to 8.4 V can be used for the receiver.
Batteries of higher voltage may damage the receiver and servos.
Electronic speed controller
(not included)
Receiver
Do not connect a separate power supply
to the receiver!

Install the Transmitter Batteries

1. Open the battery compartment lid on the reverse of the
transmitter.
2. Insert 4 fully charged rechargeable batteries or new AA
batteries observing the correct polarity.
1
GB // 16
Use only a speed controller which has the exclusive connector for
the BEC system.
Additional
channels
ATTENTION
Make sure that male and female
connectors have the correct polarity!
3. Close the cover on the battery compartment again. Ensure
that the cover clicks properly into place. Check that it is in its
correct position.
2
Connector motor
Connector battery
Power switch On-/Off
Steering servo
Channel 1
(not included)