How To Change Transmitter Batteries; Specification Of Reflex Wheel - Carson REFLEX WHEEL II Mode D'emploi

Operation of the transmitter antenna joint
GB
The transmitter antenna has a joint that allows
vertical and side-to-side positioning (from about -
10° to 80° or +/- 45°). The transmission power is
given in each position. During normal operation, the
antenna is set straight up. The antenna should not
point directly at the model, because this can
shorten the transmission range somewhat. During
special operation, therefore, a folded position can
also be an advantage.
In borderline cases (large models, terrain with a lot
of obstacles), range tests should be done.
Charging Jack
Note: ON/OFF Switch should be at "OFF"
position before charging the batteries for the
transmitter. Only Nickel-Cadmium or Nickel-
Metalhydride batteries (Ni-Cd / NiMH), such as
CARSON 609000 or its equivalents, are to be
recharged. If you attempt to recharge other types
of batteries, they may burst and cause injury or
damage to you and others. DO NOT RECHARGE
OTHER TYPES OF BATTERIES, SUCH AS
ALKALINE!

How to change transmitter batteries

• To remove the battery cover, push the cover
locking and lift the cover. Insert AA batteries
respectively NiCd / NiMH rechrgeable batteries
and pay attention to the polarityIf the transmitter
voltage indicator LED fails to register, check the
10 REFLEX WHEEL 2.4GHz CARSON Radio Control System 50 050 5004
Charging
Jack
Polarity of charging jack
Push and
lift here
Steering Rate Adjuster
Steering Rate Adjuster
Strokes of the Steering Servo Horn can be
adjusted by rotating this Steering Rate Adjuster, in
the range from 10% to 100%. The bigger the
percentage is, the more sensitively the Steering
Servo operates.
contacts, especially the negative(-) terminals and
recheck that batteries are fitted correctly. Also
make sure the batteries are fully charged.