Krups KB790 Mode D'emploi page 9

English
Place the ring seal
■
(d2) (diagram 1)
carrier
Press the assembly
■
It will click into place.
Hold this assembly upside down (locking ring base + blade
■
assembly + seal) and place it onto the glass jar, which has to be held
upside down too
knobs of the jar (there are two of them) fit into the grooves in the locking
(diagram 2)
ring base
Hold the locking ring base
■
quarter turn to lock it in place
ting up and dismantling of the base
possible only in the inverted position.
Place the assembled blender jar
■
are two possible positions: the jar handle can be in the left or right of
the control panel
less it is correctly assembled and positioned on the metal base.
Place the ingredients to be blended in the jar. Take note of the
■
following maximum levels:
- 60 oz for thick mixtures
- 50 oz for very liquid mixtures
- 6 to 8 large (1/3L or 3 cups max) ice cubes for ice crush.
■ Insert the lid stopper in the lid. Place the lid on the jar and twist coun-
ter-clockwise to lock the lid in place
Plug in the appliance. To begin blending, choose a function or speed.
■
To stop blending at any time, press OFF.
Blending speed options are Slow – 1 – 2 – 3 – 4. (Slow is the lowest speed,
4 is the highest speed).
Start on Slow
selected speed button will light up. To stop processing at any time,
press OFF (the indicator light for the speed selected will go out).
NOTE: The Slow speed can also be used to mix in
solid ingredients that you do not wish to process,
such as adding chocolate chips or nuts after blending
a batter.
7
(d3)
onto the base of the removable blade
.
(d2 + d3)
(diagram 2)
.
(B)
. For your own safety, the blender will not start un-
(b2)
and then gradually increase to the desired speed. The
down into the locking ring base
. Take care to ensure that the glass
(d1)
firmly and give the glass jar a
(diagram 2)
. For your safety, the set-
(d2 + d3)
(D)
onto the metal base
(diagram 3)
(d1)
(d4)
on the bowl
(A)
. There
.
.
are