Tineco FLOOR ONE S5 PRO Serie Mode D'emploi page 40

Brush Roller Self-cleaning
Brush Roller Cover
②
Squeeze latches on the cover and pull upward to
remove.
When replacing, always latch the brush cover into
place to avoid leakage.
1. Place the appliance on the charging base after use, the
sensor will auto-detect the level of dirt.
2. When you hear the voice prompt "please begin self-
cleaning cycle," press the self-cleaning button and
begin the process.
3. Once complete, you will hear the voice prompt "self-
cleaning completed, please clean the Dirty Water
Tank." At this point, the appliance will begin charging.
Note:
• Ensure the charging base is plugged in and the battery
level is >10%.
• Before self-cleaning cycle, please clean the DWT and
ensure the water level in the CWT exceeds 40%.
①
Rinse with water.
38