Configuration - Avidsen 123985 Mode D'emploi

D - CONFIGURATION
1
Add another camera to the smartphone
2
Preview of the video (refreshes automatically)
3
Connection status of the camera on the network
4
Deleting the camera from the list of the app's
known cameras (the camera will remain connected
to internet).
5
Access to the full confi guration of the camera
6
Access to the videos saved on the micro SD card
inserted in the camera in calendar format (optional,
not supplied)
7
Movement detection management: starting/stopping
recording on the micro SD card when a movement is
detected in the camera fi eld
The specifi c hours at which the movement detector
should be stopped/restarted can also be specifi ed,
as can the angle of detection.
8
Enabling/disabling of "Do not disturb" mode:
suppresses notifi cations in the event of movement
detection (but keeps the movement detection
active)

2.1 - CONFIGURATION

After clicking on the image of your camera from the After clicking on the image of your camera from the
list of cameras, click on the icon
full confi guration of your camera:
12
EN
1
2
3
4
5
6
to access the
7
8
9
1
2
3
4
5
6
7
8
9
BATTERY-POWERED 720P IP WIFI CAMERA
Access to the personalised name of the
camera and the version of the internal
fi rmware. The presence of a red dot indicates
the existence of an available update for your
camera.
Selection of the type of batteries used to
power the camera (rechargeable, or not)
to consequently adjust calculation of the
battery life displayed.
Setting of the time, time zone, enabling/
disabling of daylight saving time. The time
is used to programme movement detection
slots, which are also embedded in the videos
recorded.
Change of password required on login (the
password created at the time of camera set-
up)
Enabling/disabling of the camera's movement
detection. Automatic
of time slots can also be specifi ed here for
each day of the week, while the angle and
sensitivity of the movement detection can
also be adjusted.
Flip (mirror) and/or reverse the image if the
camera is installed upside down.
Setting of the incoming (camera loudspeaker)
and outgoing (camera microphone) volume
This is also where you can switch off the light
indicators at the front of the camera for more
privacy.
Full camera reset
Camera sharing: here you can display and
send the ID (UID) of your camera or an image
of its QR Code.
Note: the password that you created during
set-up will also be required to enable the
recipient to add and use the camera.
enabling/disabling