jbc AD 4300 Mode D'emploi page 3

ENGLISH
Structure of Advanced soldering stations
system
The Advanced series has basic modules giving
you full flexibility for choosing what you need for
the work in hand, the modules being supplied
separately.
Dual control unit
- AD 4300 230V
Model AD 4300 can be used with two tools
simultaneously, either handpieces, desoldering
tweezers or the AP 1300 solder feed iron. All tools
of the Advanced series can be connected to this
station except from the desoldering iron.
Handpieces
- 2210/2225
Power: 20W. For high precision work, SMD, etc.
- 2245
Power: 50W. For general soldering work.
Solder feed iron
- AP 1300
Power: 50W. Especially advantageous in high
volume soldering and wherever an extra hand
is needed.
Hot tweezers
- PA 1200
For general precision desoldering with SMD
components.
Power: 40W.
Effective power per cartridge fitted: 20W.
- PA 4200
For general desoldering and soldering work in
professional electronics.
Power: 100W.
Effective power per cartridge fitted: 50W.
Stands
- AD 8210
Stand for the 2210/2225 handpiece.
- AD 8245
Stand for the 2245 handpiece.
- AP 8130
Stand for the AP 1300 solder feed iron.
- PA 8110
Stand for the PA 1200 micro hot tweezers.
- PA 8120
Stand for the PA 4200 hot tweezers.
For a dual soldering station work properly is
necessary: the dual control unit, a handpiece or
the hot tweezers, and the corresponding stand
and cartridge.
AD 4300 dual control unit
The station is supplied with:
- Control unit.
- Connection cable to mains.
- Instructions manual.
- Transport packaging.
Technical specifications
Ref. 4300200
- Temperature selection from 100 to 371°C (±5%).
- Power: 200W.
- Safety transformer, mains separator and double
isolation, with integrated fuse of temperature
protection.
- Input: 230V 50Hz. Output: 24V.
- Electrical protection Class I.
- Total weight of unit: 5Kg.
Ref. 2210000
- ESD protected housing.
Typical surface resistance: 10
square.
Ref. 2245000
- Complies with CE standards on electrical safety,
electromagnetic compatibility and antistatic
protection.
Ref. 1300000
- Equipotential connector is earth connected to the
plug feed of the station.
RECOMMENDATIONS FOR USE
Ref. 1200000
For soldering and desoldering
- Clean the contacts and the printed circuit to
be desoldered of dust or dirt.
- Preferably select a temperature below 350°C.
Ref. 4200000
Excess temperature may cause the printed
circuit tracks to break loose.
- The tip must be well tinned for good heat
conduction. If it has been inoperative for any
length of time, it should be retinned.
Ref. 0788210
Safety measures
- Incorrect use of this tool may cause fire.
Ref. 0788245
- Be cautious when using the tool in places
where inflamable products are stored.
Ref. 0788130
- Heat can fire up inflamable products even
when they are not at sight.
Ref. 0748110
- Do not use when the atmosphere is explosive.
- Place the tool back on its stand in order to let
Ref. 0748120
it cool down before you store it.
2
5 -10 11 Ohms/