Operation - Campbell Hausfeld PW2575 Manuel Du Produit

Pre-operation (Continued)
Figure 6 – Connect high pressure hose
to pump
Figure 7– attach lance to gun
Engaged
Figure 8 - trigger locked
Figure 9 - trigger unlocked
5. Secure garden hose (not included) to
the inlet connection on pump.
6. Connect the high pressure hose to
the pump outlet (See Figures 2 and
6).
7. Attach the lance with nozzle to the
gun (see Figure 7).
trIGGer SaFety latCH
In the engaged position, the trigger
safety latch prevents the gun from
being triggered accidentally. Push the
latch fully down to engage it (See
Figure 8 and 9).
Always engage the trigger safety latch
when the unit is not in use.

operation

1. SurFaCe PreParatIoN
The following cleaning procedure will
help you organize your cleaning task
and ensures that you will achieve the
best results in the shortest amount of
time. Remember to use the spraying /
cleaning techniques mentioned in the
following section.
Before starting a pressure washer
cleaning job, prepare the surface
you intend to clean. Clear furniture
from the area and make sure that all
windows and doors are closed tightly
Also, protect all plants and trees near
the cleaning area with a drop cloth. A
covering ensures that your plants won't
be sprayed by the detergents.
2. Start uP
ALWAYS use the following start up
procedure to ensure that the unit is
Disengaged
started safely and properly.
washer, thaw the pressure washer in
a warm room before starting. do noT
pour hot water on or into the pump;
internal parts will be damaged.
1. Check engine oil levels. Add oil as
necessary.
2. Check fuel level. Add unleaded
refueling a hot engine could cause
a fire. use only fresh, clean regular
or unleaded gasoline. Close the fuel
shutoff valve during refueling.
3. Attach a garden hose to the inlet
require backflow prevention when
connecting to a fresh water supply.
Install a backflow preventer upstream
from the pump if necessary.
Note: The inlet water supply must have
a minimum flow rate of 5 gpm (19 lpm).
4. Turn the water supply ON.
the water supply is completely turned
on before operating the unit.
5. Trigger the gun until water sprays
6. Open the fuel valve by turning the
If water has frozen
7. Start the engine. Unlock the trigger
in the pressure
5
gasoline (rated 86 octane or higher)
as required.
do noT refuel
a hot engine.
side of the pump and connect it to
the water supply. Use a hose with an
internal diameter (I.D.) of 5/8 inch
(1.58 cm) and a length of 50 ft. (15
m) or less.
some local
plumbing codes
a. If inlet water pressure is over 100
psi, install a regulating water valve
at the garden hose connection.
b. Do not exceed 100° F (38° C) inlet
water temperature.
never run the
unit dry. be sure
smoothly from the tip indicating
that all air is purged from the
system. Lock the trigger safety latch.
knob counterclockwise until it stops.
Close the choke (if engine is cold)
by moving the choke ring fully to
the right. Turn the ignition switch to
"ON".
safety latch on the gun (See Figure
9). Grasp the starter rope and
brace one foot on the chassis. Point
the gun in a safe direction. While
squeezing the trigger on the gun,
pull the starter rope rapidly and
firmly (See Figure 10). Continue
www.chpower.com
PW2575