Installation Instructions - Kuppersbusch M6120.0 Mode D'emploi

Place the appliance on a stable, flat surface.
Fit the rotating base in the centre of the
microwave cavity and place the rotating
plate on top until it clicks into position.
Whenever the microwave is used, both the
rotating plate and the respective base must
be inside the oven and correctly positioned.
The rotating plate turns clockwise and anti-
clockwise.
Warning! The microwave oven may be
wrapped in a
switching it on for the first time, carefully
remove this film, starting at the underside.
In order to ensure proper ventilation for
the appliance, install the frame in the
correct way. Please refer to the following
pictures:
42
protective film.
Warning: after installing the microwave, it
is necessary to guarantee access to the
electrical socket.
During installation, ensure that the power
cable does not come into contact with the
back of the appliance, because the high
temperatures may damage the cable.
If you are installing a microwave and a
conventional oven in the same column,
the microwave must not be placed under
the oven, because of the formation of
condensation.
The electrical installation is to be set up so
that the appliance can be isolated from the
mains with a minimum 3mm all-pole contact
separation.
Suitable separation devices include e.g.
Before
cutouts, fuses (screw fuses are to be taken
This installation must comply with current
regulations.
If the electrical connection is done through a
plug and this remains accessible after
installation, then it is not necessary to
provide the mentioned separation device.
Protection against electric shock must be
provided by the electrical installation
Warning: The oven must be earthed.
The appliance must not be placed in the
vicinity of heating elements, radios or
television sets.
In case of fault, the manufacturer and the
seller will not accept any responsibility if the
installation
properly followed.
instructions have not been