Cleaning - Sonnenkonig ZERMATT Mode D'emploi

7 Cleaning

EN
TURN OF THE DEVICE AND REMOVE IT FROM THE POWER SUPPLY
Device
Every 2 Weeks
If necessary, clean
the device with a
damp cloth.
Do not use caustic
or abrasive clea-
ning agents!
Ionizer - Cleaning
Sensor - Cleaning
BEFORE CLEANING / MAINTENANCE
HEPA-Filter
Every 2 months
This fi lter cannot be
cleaned and must be
replaced
After removal, place the HEPA and activa-
ted carbon fi lter in a well-ventilated place,
as previously absorbed particles or bacteria
could now escape.
The poles of the ionizer are located under the ventilati-
on grille of the air outlet and can be cleaned with a cot-
ton swab� To do this, open the cover on the upper side:
The sensor is located on the left side of the handle un-
der the cover provided for this purpose� It can also be
cleaned with a cotton swab after removing the cover�
66
Activated carbon filter
Every 2 months
Thoroughly vacuum
the front of the fi lter
with a vacuum clea-
ner.
Pre Filter
Every month
Vacuum the fi lter
thoroughly with a
vacuum cleaner or
wash it under run-
ning water and let it
dry.