Getting Started; Select The Display Language, Acknowledge The Crossover Type And Cancel The Demonstration; Set The Clock And Date - Kenwood KDC-BT665U Mode D'emploi

Basics
To On the faceplate
Turn on the power Press B SRC.
• Press and hold to turn off the power.
Adjust the volume Turn the volume knob.
Select a source • Press B SRC repeatedly.
• Press B SRC, then turn the volume knob
Change the display Press DISP repeatedly. (Page 31)
information
4
ENGLISH
within 2 seconds.

Getting Started

1
Select the display language, acknowledge the crossover
type and cancel the demonstration
When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES], see page 6), the display shows: "SEL LANGUAGE" "PRESS"
"VOLUME KNOB"
1 Turn the volume knob to select [EN] (English) / [RU] (Russian) /
[SP] (Spanish) / [FR] (French) / [GE] (German), then press the knob.
[EN] is selected for the initial setup.
Then, the display shows: "2-WAY X ' OVER" or "3-WAY X ' OVER"
"VOLUME KNOB" "TO CONFIRM".
2
Press the volume knob to acknowledge the current crossover type.
• To change the crossover type, see "Change the crossover type" on
page 6.
Then, the display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB".
3 Press the volume knob again.
[YES] is selected for the initial setup.
4 Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock and date

1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [CLOCK], then press the knob.
"PRESS"