Oeuf Perch 1PTB01 Instructions De Sécurité page 4

WARNING
Before each usage or assembly, inspect toddler bed for damaged hardware, loose joints,
missing parts, or sharp edges. DO NOT use toddler bed if any parts are missing or
broken. Ask your dealer or write to OEUF for replacement parts and instructional literature
if needed. DO NOT substitute parts.
Upon completion of assembly, be sure all screws and bolts have been tightened securely.
A periodic check should be made of all screws and bolts and retighten if necessary.
NEVER use plastic shipping bags or other plastic film as mattress covers because they
can cause suffocation.
DO NOT use a water mattress with this toddler bed.
Care & Maintenance
• When cleaning your crib/bed rail, use a nontoxic, non abrasive cleaner. Mix a solution of water, if
necessary, with a small amount of a mild detergent. Apply to bed surface with a damp cloth.
• Always lifts the unit. Do not push or drag it to avoid damaging the base.
• It is important that the humidity levels in the room be controlled from extremes of too much
humidity or too little. The bed should not be placed directly next to air-conditioning outlets, fire
places, radiators, space heaters, humidifiers or dehumidifiers. Exposure to extreme variations of
temperature and humidity can damage wood products.
• Keep the bed out of direct sunlight. UV rays may fade colors and in some cases darken them. It
can cause crazing or hair line cracks in the finish. White finishes will darken naturally over time
and exposure to direct sunlight will hasten this natural process along with some wood darkening;
this is not considered to be a quality defect.
• If you need to put your crib/bed rails in storage for any period of time do not store it in a damp
• or hot environment. Allow air flow around the furniture and do not stack anything on it.
Check List
• The crib/bed is ready for use only when the bed rails are properly installed. Please check carefully
before use.
• Always check the bed is free from damage before use. Do not use product if any damage is
present.
• Regularly check that all assembly fittings are always tightened properly and retighten as
necessary.
4