ScorpionExo EXO-COMBAT Mode D'emploi page 4

Installing The Mask
EN
IMPORTANT NOTE:
The Mask is NOT FOR PROTECTION but for comfort use.
Push the mask into two holes in front of the sleeve
until you hear "click" sound.
Be sure to hear this "click" sound to secure the mask.
Then pull the mask to outer direction several times
to check whether it is securely assembled to the helmet.
5
Securing and Wearing
Your Helmet
Do not simply pull your helmet down onto your head like a hat. Your
ScorpionExo ® helmet should be worn as follows: Using both hands grab
the helmet's bottom rim while holding the chin straps with your thumbs.
Then "roll" the helmet onto your head starting at the forehead. Continue
rolling the helmet on towards the back of the head until it comes to rest
with your head fully in contact with the inner lining and cheek pads.
HOW TO USE CHINSTRAP
Nylon tab
While you are wearing your helmet,
Locking brace
grasp the notched arm of the chinstrap
Open slot
with your right hand, and the locking
Notched arm
mechanism with your left hand. Pull
the nylon tab with your thumb and
forefinger to open the locking brace.
Insert the notched arm into the slot.
Release the nylon tab to lock the arm
in place. Adjust as needed.
FIRMLY AND SECURELY FASTEN YOUR CHINSTRAP.
Check your chinstrap for tightness occasionally as vibration or wind may
loosen it.
Cleaning Your Helmet System
None of the components of your ScorpionExo ® helmet can be damaged
by water. All headliners and sweat-wicking cheek pads are machine
washable. Wash them with a mild detergent in warm water and allow to
air dry. Hand washing is recommended, but machine washing is also
permitted. Use the "delicate" cycle to prevent the agitator
from damaging the sweat-wicking material covering the liner parts,
we recommend to place the parts in a washing bag. Do not place
lining parts in the dryer: Excess heat may damage the foam and
coverings. The sun visor may be cleaned with plastic polish or
mild soap and water. The shell of your helmet should be cleaned
using only a mild detergent and water.
Warning
For your safety, it is important that you completely read the
owner's manual and all warning labels.
DO NOT
DO NOT ride without snugly fastening your chinstrap.
DO NOT clean your helmet with petroleum products, solvents,
benzene, thinner or cleaning agents.
DO NOT paint over your helmet's finish without totally protecting
and isolating the shock-absorbing liner and plastic parts.
Your warranty will otherwise be invalidated.
DO NOT drop your helmet from any height onto a hard surface.
This could cause damage to your helmet's finished and/or
decrease its ability to protect you.
DO NOT place your helmet on your motorcycle's rearview mirror:
The sharp pressure from the mirror's edge will compress and
damage the helmet's shock-absorbing liner.
DO NOT place your helmet on the motorcycle's seat or fuel tank.
It can easily roll off and hit the ground causing damage to
the helmet. It is best to place your helmet on the ground so it
cannot fall in any direction.
DO NOT ride with a scratched faceshield. This can impair your
vision, especially at night.
DO NOT modify any part of your helmet, e.g., drilling the shell or
cutting and pressing the shock absorbing liner. Installation of sound
systems, speakers and microphones reduces your helmet's ability to
protect you and is not recommended.
DO NOT use the helmet again if it has either been dropped or
involved in an accident. Replace it even if the damage is not visible
to the naked eye.
DO NOT wear a dark or tinted faceshield (including the retractable
SpeedView Sunvisor) in dark or poor visibility riding conditions.
TM
DO NOT place your headliners and cheek pads in the dryer after
washing. Allow them to air dry.
DO NOT attempt to remove, change or replace your faceshield while
riding your motorcycle or ATV.
DO NOT use paint which requires heat curing.
Warranty
All ScorpionExo™ helmets have a warranty of 5 years.
Although there is no visible damage on your helmet, general wear
and tear over time may affect overall function of protective helmet
and increase the risk of injury in accident. It is advisable to replace
your helmet no later than every 5 years from purchase.
Should you have a warranty claim, go to your Scorpion dealer with
your invoice (this is you purchase proof, it's necessary in order to
start the warranty process). You can find our dealers' list on your
website: http://www.scorpionsports.eu/english/dealers/find-a-dealer/
find-a-dealer.html (choose your country and then the
location) The dealer will contact our after sales service
and start the warranty process in order to check
and/or repair your helmet.
EN
6