ScorpionExo EXO-COMBAT Mode D'emploi page 3

Helmet Overview
EN
FRONT VIEW OF THE HELMET
Front
Intake Vents
Speedview
Sunvisor
Detachable
Front Mask
Quick Release
Chinstrap
Buckle
WARNING
Always check to make sure the crown liner, neckroll and
cheek pad are installed before using the helmet.
A helmet without the crown liner and/or cheekpad may
increase your risk of serious injury or death.
3
SpeedView®
Retractable Sun Visor
USING SPEEDVIEW® SUN VISOR
To lower the sunvisor, To raise the sunvisor,
simply pull the SpeedView ® simply push the SpeedView
®
Sunvisor lever down. Sunvisor lever up.
REMOVING SPEEDVIEW® SUN VISOR
Firmly hold the sun visor Repeat to release the opposite
side. Reverse process for
with your hand and gently
pull one side out away from installation.
the helmet to release.
Removing The Mask
First, push the button
(in red circle) on one side
of the sleeve.
While pushing the button
® completely with one hand,
pull out the mask with
the other hand.
Do the same for the other
side of the sleeve.
Removing and Installing
The KwikWick® II Liner
REMOVING THE CROWN LINER
After removing the mask,
you can remove the crown
liner.
Detach 4 snaps in front and
back of the crown liner, then
pull it off from the helmet.
Reverse the process to
install it again.
REMOVING THE NECK ROLL & CHEEK PAD
Pull it off by detaching
6 velcro points around it.
Reverse the process to
install it again.
EN
4