LENCO DPA-24 Mode D'emploi page 5

1. Insert one end of the USB cable into USB on PhotoAlbum and the
other end into your computer's USB port. The battery level indicator
flashes on the display.
2. Charging time is approximately three hours, when the battery is
fully charged,
the battery level indicator stops flashing.
Installing the Software / Hardware
IMPORTANT: You must install the software to your computer before
connecting the device to your computer for the first time.
1. Insert the CD-ROM and run the file SETUP.EXE; Follow the
on-screen instructions.
2. The application Photo Viewer will be installed on your computer and
a short cut to the application will appear on your desktop.
DO NOT LAUNCH THE SOFTWARE YET.
3. After the software is installed, connect the device to the computer
with the USB cable supplied. The hardware drivers will be installed
automatically. Follow the on-screen instructions and accept the
installation screens that appear.
4. After hardware installation is complete, launch the Photo Viewer
application from the shortcut on your PC desktop.
NOTE: If you are unable to launch the software or connect to your
Photo Album, go to the Troubleshooting of the manual for
more information.
4