Alber PS4820 Mode D'emploi page 3

DE
Das oben abgebildete Etikett befindet sich auf der Unterseite des Ladegeräts. Informationen zu den
technischen Angaben und den verwendeten Symbolen finden Sie auf den vorherigen Seiten.
Bitte verhalten Sie sich umweltbewusst und führen Sie dieses Produkt am Ende
seiner Nutzungsdauer Ihrer regionalen Recyclingeinrichtung zu.
Bitte informieren Sie sich über die in Ihrem Land gültige Gesetzgebung bezüglich
der Entsorgung, da die WEEE-Verordnung nicht in allen europäischen Staaten für
dieses Produkt Anwendung findet.
Alternativ werden diese Komponenten auch von Alber oder den Alber Fachhändlern
zur fachgerechten und umweltschonenden Entsorgung zurückgenommen.
SAFETY INSTRUCTIONS
§ Please read these operating instructions before using the device.
§ The PS4820 charger is only permitted for charging the e-motion M25.
§ Use with other products is not permitted and can result in significant damage to this charger and to
the other equipment.
§ Use the charger only if the connecting cables and the housing are undamaged.
§ Do not pull on the connecting cables as this could damage or break the wires.
§ The device is intended for use in dry rooms and not permitted to be used outdoors.
§ If the charger is moved from a cold environment to a warm room, condensate may form. Only use the
charger once it is completely dry inside and out! This could take several hours.
§ Ensure there is adequate ventilation when using the device.
§ Do not move the device along with the wheelchair.
§ When charging is complete, remove the mains plug from the mains outlet and disconnect the charge
cables from the e-motion drive wheel.
§ When using the device, set it down on its underside and ensure that the device is not covered.
§ Position the device such that the mains plug can be unplugged from the mains outlet at any time as
this is used to switch the device off.
§ Do not open the device.
§ Supervise children and keep them away from the device when it is being used.
§ Volatile gases may be produced during charging. Do not use the device in the vicinity of naked
flames or ignition sources.
§ Do not make any unauthorised changes to the device!
PURPOSE
The PS4820 charger is intended for charging the drive wheels of the e-motion M25. The charger is desig-
ned for stationary use and is not suitable for being moved along with the wheelchair. The charger can
be used throughout the world and automatically adapts to the respective mains voltage. Please use a
corresponding mains adapter if required. The proper charge procedure is primarily determined by the
rechargeable battery itself. For this reason, please pay attention to the charge monitoring display on
the e-motion drive wheels. If necessary, please check the electrical connections and ensure that the
charger is used free standing.
OPERATING MODE DISPLAY
LED Colour LED Mode Status
Red Illuminated Fault
Orange Illuminated Ready for use
Green Flashing Charging in progress
Green Illuminated Charging completed
EN