EnviroBoss EB60 Manuel Du Propriétaire page 3

If the EB60 onboard diagnostics discover a problem, the
unit will display an error message. See "Error Messages"
below for an explanation of each message.
Control Panel Guide
ON/OFF. Press to turn the unit on or off. When the ma-
chine is turned on, the display normally reads PLEASE
WAIT COMP. DELAY and performs a numeral count-
down for a maximum of 60 seconds to 0. This delay al-
lows time for refrigerant pressures to equalize for easier
starting. Once the unit completes the compressor delay,
the display shows UNIT ON XX HRS and cycles be-
tween INLET XX°F and INLET XX%. NOTE: If no com-
pressor delay countdown is displayed, a delay is not
necessary and the machine will begin operation immedi-
ately.
DISPLAY MENU. Press to cycle through the display of
additional dehumidifier conditions and User Settings. To
return to the main menu, press the ON/OFF key once.
MENU SELECTION. Press to change the values of the
"User Defined" settings. The MENU SELECTION key
acts as the UP key for adjusting the setpoint for Humidi-
stat mode operation. See User Settings Menu (below)
for details.
PURGE. Press to empty water from the condensate
pump reservoir. The display will read PUMP PURGING
with a numeral countdown.
NOTE: During normal operation, the pump purges auto-
matically.
07-02330B EB60 3 EnviroBoss