Faro OVNI Instructions D'installation page 32

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA
SICHERHEITSHINWEISE / VEILIGHEIDSINSTURCTIES INSTRUZIONI DI SICUREZZA
OPERATION
1. Your fan can be operated from the remote control (if installed), giving you the three speed choices
and full dimming light control with auto return to the brightness level last set before the light was
turned off.
2. if using a wall mounted control instead of the wireless remote control, follow the operation
directions supplied with the wall control. Most are 3 speed with light dimmer.
The slide switch on the top of the fan housing controls forward or reverse rotation. Make sure switch is not
stuck between forward and reverse position.
IMPORTANT: to prevent damage for fan motor when changing direction of rotation, please be sure that fan
is off and blades have stopped moving completely before attempting to change direction.
CARE AND CLEANING
Periodic cleaning of your new ceiling fan is about the only maintenance that is needed. Only use a soft
brush or lint free cloth to avoid scratching the finish. NO NOT use water when cleaning your ceiling fan. It
could damage the motor or the wood blades, and/or create the possibility of electrical shock.
NOTE: periodically it may be necessary to re-tighten blade screws to prevent clicking or humming sound
during operation. This is especially true in climates with broad temperature and humidity ranges and the
fans with painted or high gloss blades. When dusting the blades, you must support the blade to prevent
bending no pressure should be applied to the blades.
If you experience any flaws in the operation of your fan, please check the following points:
TROUBLESHOOTING IN CASE OF DIFFICULTY
CAUTION: Switch off the power supply before carrying out any of these checks.
1. If will not start: Check main and branch circuit breakers and/or fuses. Check line wire connections
to fan. Make sure forward/reverse switch is set to one or the other position, not stuck in between
2. If the fan is noisy: Check and make sure that all screws in motor housing are snug (but not over
tight). Check that the screws securing blades to the motor are tight. Check all glassware is finger
tight and that bulb are well held in the sockets, if a light kit is used. Check that the canopy is firmly
attached to hanging bracket and not vibrating against ceiling.
3. If fan wobbles: Check all blades are firmly screwed into motor. Check to make sure that light is
firmly attached and that all glassware and shades are fastened properly. Wobble can also result
for even the smallest deviations in distance for blade tip to blade tip, if measurements from blade
tip to blade tip are not equal, loosen screws connecting blade to motor one at a time and adjust
blade so that distance are equal. Interchanging adjacent blades may redistribute mass and result
in smoother operation.
Faro
- 31 -