Carrier Comfort Serie Manuel D'installation page 8

Installation
PARAMETER
FEATURE
NUMBER
MAX COMP FREQ 132
REQUEST FREQ 133
REAL FREQ 134
COMP RUNTIME 135
CDU CAPACITY 136
T° WA 137
T° WC 138
T° REFR. 139
SYSTEM MODE 140
DEF MODULE 141
GMC SW VERSION 142
GMC SW RELEASE 143
WATER PUMP TIME 144
CURRENT WSP 145
DRY CONT OFF 146
8
DESCRIPTION
Maximum Compressor Frequency calculated
by GMC Control
Requested frequency by system Control
Current frequency by the Inverter Control
Number of hours the compressor has been
running since the beginning
CDU Capacity HP
Entering Water Temperature (EWT)
Leaving Water Temperature (LWT)
BPHE Refrigerant Temperature
Operating mode requested by the Heat
Pump Control:
0. Off
1. Stand by
2. Cooling
3. Heating
4. Booster Heating
5. Booster Cooling
6. Rating Heating
7. Rating Cooling
8. Freeze Protection
9. Defrost
10. High temperature Protection
11. Time guard
12. System Fail
Display the fault code of the unit. A list of
defined fault and the relative fault Number
will be defined. All the fault codes have to be
displayed. (Refer fault code table)
Heat Pump Control PCA Software Version
Heat Pump Control PCA Software Release
This parameter is indicating the total water
pump run time and it's a cumulative number.
The installer can force a new starting value
This parameter will display the current WSP
defined by the System Ctrl. This value is the
calculated WSP (applying climatic curve
if any, envelope protection or any other
protection functions if applicable) before the
Temperature calculation function.
1. Standard OFF
2. Force Frequency to Zero
VALUE
DEFAULT
RANGE
VALUE
Min Max
Read
- -
value
Read
- -
value
Read
- -
value
Read
- -
value
Read
- -
value
Read
- -
value
Read
- -
value
Read
- -
value
Read
0 12
value
Read
3 31
Value
- - -
- - -
- - -
- - -
1 2 1
INSTALLER
VALUE
-