Publicité
Les langues disponibles
Les langues disponibles
4.5- Stationary use
The tool can be used in stationary mode:
Place tool on workbench or flat surface (strong and
stable surface) with the nozzle pointing up (see
Fig.2a and 2b).
Note : Secure the power cord to prevent it from
pulling the tool
V. OPERATION
5.1- Intended use
- The product is intended for indoor domestic use.
- The product is intended for stripping paint, forming or moulding (plastics) and heating (e.g. thermo
retractable sleeves ...)
- Do not use the product for applications for which it is not intended and for uses not described in the
manual.
- Any other use, other than that described in the instructions, is likely to damage the tool and to put
the user in serious danger
5.2- Operation:
- Wear appropriate protective equipment.
- Prepare material for work
- Secure workpiece if necessary.
Do not use your own weight or body to hold material.
- Only for PRDECA2000KIT/311019: insert accessory in main nozzle.
- Firmly hold tool to and always maintain a balanced and secure position.
- Place nozzle over material. Do not make sudden movements.
- Press on switch to start operation and adjust temperature as required..
- Once work is finished, stop product by placing the switch on "0".
Note: do not put down product until the nozzle is completely cooled down. Do not leave the product
unattended while nozzle is hot.
5.3- Examples of use
ATTENTION: examples for reference purpose only.
Stripping of paint with or without the scrapper
Fig.2a
Moulding of plastic
Fig.2b
Page 18 / 28
Publicité
