Ingersoll Rand UP6 15 Mode D'emploi page 35

5
7
9
2
1
0 bar
0 psi
12
1
2
DISASSEMBLING THE UNIT
The unit has been designed and constructed to guarantee continuous
operation.
The long service life of some components such as the fan and
compressor depends on good maintenance.
The unit must only be disassembled by a refrigerant specialist.
Refrigerant liquid and lubricating oil inside the refrigeration circuit must
be recovered in compliance with current norms in the country where the
machine is installed.
http:/air.ingersollrand.com
6
1
8
0 bar
0 psi
10
0 bar
0 psi
DRYER OPTION
RECYCLING DISASSEMBLY
Frame and panels
Heat exchanger (cooler)
Pipes
Drainage system
Heat exchanger insulation
Pipe insulation
Compressor
Condenser
Refrigerant
Valve
Electrical cable
REFRIGERANT LEAKS IN THE REFRIGERATION CIRCUIT
The unit is dispatched in perfect working order, already charged.
Refrigerant leaks may be identified by tripping of the compressor
overload protector (SK).
IF A LEAK IS DETECTED IN THE REFRIGERANT CIRCUIT, SEEK
TECHNICAL ASSISTANCE.
REFRIGERANT CHARGING
THIS OPERATION MUST ONLY BE PERFORMED BY A
REFRIGERANT SPECIALIST.
WHEN REPAIRING THE REFRIGERANT CIRCUIT, COLLECT ALL
THE REFRIGERANT IN A CONTAINER AND DISPOSE OF IT IN THE
APPROPRIATE MANNER.
CHARACTERISTICS OF REFRIGERANT R134A
In normal temperature and pressure conditions the above refrigerant is
a colorless, class A1/A1 gas with TVL value of 1000ppm (ASHRAE
classification).
If a refrigerant leak occurs, thoroughly air the room before commencing
work.
33
Steel / epoxy resin polyester
Copper
Copper
Polyamide
EPS (polystyrene sintered)
Gum synthetic
Steel / copper / aluminium / oil
Steel / copper / aluminium
R134a
Brass
Copper / PVC
UP6 15, UP6 20, UP6 25, UP6 30