LG HN7413AG Mode D'emploi page 28

T RO U B L E S H O OT I N G
BEFORE CALLING FOR SERVICE
Problem
appears in the
timer display
appears in the
timer display
appears in the
display and a number
appears in the timer
display
flashes in the
display
28
Possible Causes
• Control pad was touched too long.
• Supplied voltage to cooktop is
t o o o l . w
• Electronics fault error message.
• Power outage or initial startup.
Solutions
• This message will appear if any pad except the Timer
or pads is touched for more than 10 seconds.
It will also appear if liquids or objects are spilled or left
on the controls area. To clear the error code, remove any
liquid or objects from the controls area and press the
POWER pad to reset the cooktop.
• If the voltage of the power supplied to the cooktop is too
o l w i , c t n a o n o t e p a r e t p o r e p
code. This may be caused by reduced voltage being
supplied to the house circuit. If connections are
correct and the supplied voltage returns to normal,
the code will disappear.
• Turn the cooktop OFF; then shut off power at the fuse or
circuit breaker for about 30 seconds. Turn power back
on to the cooktop and turn the cooktop on using the
POWER pad. If the error message is still displayed, call
for service.
• When the cooktop is first turned on or after a power
outage, will blink in the display for 90 minutes or
until the POWER pad is touched for 2 seconds.
y l r a d n i w s l l o h w h t s i r e r o r