Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
ASSEMBLY INSTRUCTIONS
1.Attach wheel assembly (M)to base (F).Line up holes in wheel bracket with corresponding holes in base, insert
M6 x 12(BB) through holes, and finger tighten two M6 flange nuts(CC).Be sure that the wheel assembly is parallel
to the base, and fully tighten bolts.
Hardware Used
BB M6*10
*8
CC M6
*8
AA 3/16-24
*8
2.Warning: Remove Protective cover before assemble .
Note: If necessary for proper alignment of reflector sections, loosen each
bolt prior to further assembly and retighten after sections are aligned.
3.1 Slide two reflector panels together.
Insert one bolt M6x10 (II). Slide One washer (HH) Over treaded end of
bolt M6x10 (II) and screw on cap nut (JJ) Loosely.
www.sunred.nl
Publicité
