Table des Matières
Publicité
Auto Menu's
Menu 76 – Auto Record and Rehearse
0= ADR Mode
The Auto-Record and Rehearse keys may be one shot Commands (1= Cmd, 2= Editor) or
modes (0= Mode) that change the operation of the unit. Loop operation is only available when
the mode is selected.
Select Auto, Rehearse, Manual, Review Mode by depressing Mode key.
0= Mode
Leave Mode by depressing illuminated Mode key.
Whilst mode is active the Locate command will locate pre-roll before record
in. Record On and Record off commands are global, the record advance
may be changed by entering required record advance followed by Store
followed by Record.
Perform an auto edit, rehearse, review, manual by depressing the selected
1= Command
command key. The system will locate record in and perform edit/rehearse.
Whist active the selected command LED will be illuminated. Once finished
the LED will extinguish. Record On and Off commands are performed
individually by each serial port, the record advance for each machine may
be individually adjusted using Root | Iface | Record | Menu 40:- Record
Advance.
This is the same as 1= Cmd except that, all group enabled machines are
2= Editor
selected and the system then performs an auto edit/Review. Once the edit
is finished the machines are released and become individual again.
Menu 77 – At end of Auto Record
0= Redo
1= Stop
When the auto record out is activated this parameter selects what the system will do next.
Menu 78 – ADR Backup Machine
0= None
When either Auto-Record or Manual-Record mode are enabled a DAT machine may be used
as a backup recorder on the specified serial port.
Note: Once a backup DAT machine is enabled an extra delay of 70 frames is added to allow
for the lockup and PNO record of the DAT. If the pre-roll is to short the system will not go into
record even if locked.
Menu 79 – Get loops from Keyboard or CBServer
0= Keyboard
2017 CB Electronics
Clavier de contrôle TFT
Menu 76 – Auto record and Rehearse
1= Command
Menu 77- At end of Auto Record
2= Goto In
Menu 78 – ADR Backup Machine
1= A
2= B
Menu 79 – Get loops From
3= Review
4= Play
3= C
1=CBServer
2= Editor
5= All Stop
4= D
5= E
Page : 32
Publicité
Table des Matières
