Table des Matières
Publicité
Unit Generic Menu's
Menu 28 – Macro protection
0= Off
1= On
This menu provide two functions:
1) Enable and disable changes to the keyboard, Macro keys, pre-roll...
2) Control access to the EEPROM and FACTORY setups.
The addition of an EEPROM to the system allows the user to select between three different
settings as follows:
1) Current: destroyed when Read User or Read Factory are selected or a Hard Reset
command.
2) User: selected by Read User or a hard reset command.
3) Factory: selected by Read Factory.
This Menu controls access to user settings and the EEPROM:
Macro's can be changed from the keyboard.
0= Off
System Track Arm Keys may be changed from the keyboard.
Pre/Post Roll May be changed from the keyboard.
Macro's cannot be changed from the keyboard.
1= On
System Track Arm Keys cannot be changed from the keyboard.
Pre/Post Roll cannot be changed from the keyboard.
On exit from Setup the unit will read User Setup from EEPROM, the macro
2=Read User
protection will default to 1= On. This is activated on leaving setup.
Simultaneous depression of [Recall] and [7] will read the User setup.
On exit from Setup the unit will read the Read Factory Setup from EPROM,
3= Rd Factory
the macro protection will default to 1= On. This is activated on leaving
setup.
Simultaneous depression of [Recall] and [4] will read the Factory setup.
Setup the unit to work in your preferred manner then select to write current
4= Wr Usr
setup to EEPROM, the macro protection will default to 1= On. This is
activated on leaving setup and may take up to 20 seconds to complete the
write.
Simultaneous depression of [Store] and [7] will write to the user setup to
memory.
Menu 29 – Power up Settings
0= Battery ram
2017 CB Electronics
Clavier de contrôle TFT
Menu 28 – Macro Protection
2= Read User
Menu 29 – Power Up Settings
3= Read Factory
1= reset to User
4= Write User
Page : 21
Publicité
Table des Matières
