Table des Matières
Publicité
Menu 51 – Park Offset / Locate Ahead
0=
1=
0frm
5frms
10frms
The park offset is not normally used for video machines. A park offset will allow more
consistent starts and allow time for the machine to lace.
Menu 52 – Wait for Stable Code
0=
1=
2=
0frm
3frms
6frms
After the initial play command is issued the SR-4 will wait for the specified number of frames
before attempting to servo the slave machine. This parameter is useful on machines (for
instance the DA-88) which give incorrect positional information during start-up.
Menu 53 – Minimum Slew Speed
0= Off
Menu 51 – Maximum Slew Speed
0
1
This parameter limits the maximum speed of the machine when locking. When locking the
lock algorithm determines the speed of the machine dependant on the distance to lock, the
father away from lock the faster or slower the machine. Some servo's lose stability at high
speeds, hard disk machines may not be able to output audio above a certain speed.
Menu 55 – Wait for Lock Tally
0= Yes
Normally set to Yes for tape based machines, after slewing to lock, the system waits for 5
frames and then a lock tally from the machine before checking for lock. Set to NO for Pro-
Tools, the system will then check after 5 frames without waiting for a lock tally.
Menu 56 – Report Lock On
0= Servo Lock
A number of machines do not support a servo lock tally (MX2424 as a master, Doremi without
video syncs). This parameter allows you to select the play tally as a lock tally. For ProTools
use 2=Play tally if Master.
2017 CB Electronics
Clavier de contrôle TFT
Menu 51- Park Offset / locate Ahead
2=
3=
15frms
20frms
Menu 52 – Wait for Stable Code
3=
4=
9frms
12frms
Menu 53 – Minimum Slew Speed
1=
Menu 54 – Maximum Slew Speed
2
3
Menu 55 – Wait for Lock Tally
Menu 56 – Report Lock On
1= Play Tally
4=
5=
25frms
30frms
5=
6=
15frms
18frms
2=
4
5
6
6=
7=
35frms
40frms
7=
8=
21frms
24frms
3=
7
8
1= No
2=Play Tally if Master
Page : 27
8=
9=
45frms
9=
27frms
9=Max
Publicité
Table des Matières
