Install The Remote Control Dock - Kohler K-7421 Guide D'installation

Tab
Back
Plate

1. Install the Remote Control Dock

IMPORTANT! Carefully set the small screws in the screw pack
aside. They will be used in a later step.
Position the back plate at the installation location, tab on the
upper right corner.
Confirm the back plate is level. Mark the location of the screw
holes on the wall using the mounting plate as a template.
Drill a 3/16" hole at each mark. Install the provided anchors.
Attach the back plate to the wall with the provided screws.
Position the docking station on the back plate.
Mark the location of the bottom holes.
Remove the docking station and drill a 3/16" hole at each mark.
Install the provided anchors.
Position the docking station on the back plate.
Secure the docking station with the provided screws.
Attach the adhesive side of the pad to the docking station over
the screws.
Kohler Co.
Docking
Station
Pad
5
Screw
1197250-2-B