OZ Lifting Products TELE-PRO OZTP500DAV Manuel De L'opérateur page 7

Assembly Diagram
1. 2.
5.
NOTE: Further disassembly of the boom extension/retraction mechanism is not normally needed.
If full disassembly of the inner boom components is required, please contact the factory. Any
unauthorized removal of the inner boom components will void the warranty.
Field Test
There is no ASME standard for davit cranes. OZ Lifting Products davit cranes have a minimum 3:1
design factor. We individually load test and certify every davit crane to 125% of the rated capacity.
A test certificate is generated that includes the serial number and a photo of the davit under load.
If a load test is required on site, we recommend contacting a civil engineer to determine if the base
has been properly mounted to a secure location. We provide the information on the moment a base
would pull away from the mounting bolts.
Installing the Cable
The OZ Lifting Products LLC® cable assembly that can be ordered with the TELE-PRO DAVIT CRANE
by OZ Lifting Products LLC® may come with a swaged ball on one end to facilitate easy assembly.
Standard bare end cable can also be used. The hardware for bare end cable installation is included.
Please refer to the accompanying winch owner's manual for instructions on installing a bare end
cable.
To install the OZ Lifting Products LLC® supplied cable with swaged ball end:
1. Lay the cable out on a flat surface to ensure it is not knotted or looped.
2. Locate the ball end of the cable.
3.
6.
EN pg.7
4.