Publicité
Les langues disponibles
Les langues disponibles
EN
Insert the joint plate to the hole of the big board
as picture 1 shows.
Note: let the plate feet aiming at the holes of the
big board, which will be easier to install.
Pull the stand foot of the ironing board to 90
degree, and fixed; Loosen clip and extend the
pole, then lock the clip. Refer to picture 2.
Fix the ironing board to the telescopic poles, aim
at the holes and screw the M8 screws by hand as
picture 3 shows.
Put the two supported poles of the ironing board
onto the extension poles like picture 4 shows.
Picture1
Picture2
Picture3
Picture4
USE
Filling with water, unscrew the safety cap from
unit, reference to figure 12 filling water into boiler.
Caution: Only filling water, no any other cleaning
detergent allowed.
NOTE: To prolong the lifetime of your steamer,
we recommend using distilled or de-mineralized
water.
11
Publicité
